The best 3D-printed Star Wars blaster prop for cosplay depends on which character you are building and how much assembly you want to do. For a first prop, the DL-44 (Han Solo) is the easiest entry point at under £35. For screen accuracy on a trooper build, the E-11 is the one people recognise instantly. Below is a full comparison across six of the most requested builds.
How do the six blasters compare?
| Blaster | Character | Price | Build | Best for |
|---|---|---|---|---|
| DL-44 | Han Solo | £32.99 | Push-fit, no glue | First-time cosplay builders |
| IB-94 | Din Djarin (Mandalorian) | £35.99 | Made to order | Mandalorian costume builds |
| Blurrg-1120 | Hera Syndulla | £38.99 | Glue build | Compact holdout prop, smaller bags/props |
| EE-3 | Boba Fett | £43.99 | Push-fit, no glue | Bounty hunter builds, display or con floor |
| E-11 | Stormtrooper | £45.00 | 48cm, actuating trigger, extendable stock | Full trooper armour builds needing screen accuracy |
| MW-20 Bryar | General Star Wars / Andor era | £45.99 | 8 colour options | Collectors who want colour options to match a specific costume |
Which one should you actually build first?
If this is your first prop build, start with the DL-44. It is push-fit with no glue required, priced under £35, and instantly recognisable at any con. If you are building a full Mandalorian or Stormtrooper costume and need the blaster to match, go with the IB-94 or E-11 instead, since character accuracy matters more than build simplicity for a full costume.
Push-fit prop kit in gray, matte black, or galaxy black. Printed in durable PLA.
48cm assembled, with an actuating trigger and extendable stock, in grey or matte black.
Frequently asked questions
Do these blaster props need glue?
It depends on the model. The DL-44 and EE-3 are push-fit with no glue required. The Blurrg-1120 is a glue build. Check the individual product listing before you buy if this matters for your build timeline.
Are these blasters screen accurate?
Each is 3D printed with reference to the on-screen design, though as with any prop kit small details vary from the original screen-used pieces.
What material are they printed in?
PLA, printed to order, which is durable enough for convention use, display, and photos.
Which is the cheapest blaster to start with?
The DL-44 at £32.99 is the least expensive of the six and the simplest push-fit build.
Browse the full blaster range
Dozens of Star Wars blasters and prop kits, made to order in the UK.
Shop Prop Gun & Blaster Kits →